Note: Support is no longer provided for this product. Please use Cloud Management as an alternative.
The NoTouch Center's group management allows you to configure and manage groups of ThinPrint Hubs identically. This is necessary, for example, if load balancing has been set up between two or three hubs.
The following describes only those functions that apply exclusively to the groups. Functions that are the same for hubs and groups can be found in the Managing Hubs section.
Group menu
Buttons
- The group menu opens when you select the name of a group, e.g. Netherlands.
Here you will find the following buttons in the upper right corner:
 | add an unassigned Hub to this group |
 | rename this group |
 | add a subgroup tothis group |
 | delete this group |
Configuration tab
Administration
You have the following input and selection options in this menu:
| Description | description field for this group |
| Firmware Pool URL | see Multiple image pools in the Stratodesk knowledge base |
| Assigned to | assignment of this group to a higher-level group; this can be changed here |
Automatic assignment
For Automatic assignment see the article Auto-assign of the Stratodesk knowledge base.
Actions tab
- On the Actions tab, you can reboot the Hubs of a group, announce them to the NoTouch Center, reset the authentication key (Mkey Auth Token), or perform the automatic assignment to a group again (Re-run Autoassign).
- Confirm with Execute.
Acl tab
- On the Acl tab you can assign the users of the NoTouch Center one of the rights Read or Write for this group.
All rights set here are inherited to both subgroups and Hubs. Therefore, they cannot be changed there. - Confirm with Save.
Acl stands for Access Control List
Info tab
- The Info tab displays the hubs of this group or of a subgroup with status, IP address and firmware version.
- Click on
to show details of the Hubs.
Licenses tab
The Stratodesk licenses shown here are not relevant for ThinPrint Hubs.
See the Licensing section instead.
Group Settings menu
The settings in the Group Settings menu correspond to those of the individual hubs, but are made here for groups of hubs.
For the individual functions of this menu, see the section Managing Hubs.
